The 360 Control Box Slide-Out PCB must have its firmware updated to minimum version 1.1.22 in order to prevent further lock ups caused by long period of dormant use. If the 360 Control Box Slide-Out cannot be flashed with updated firmware at the location by a Brunswick representative, then send the 360 Control Box Slide-Out PCB only back to Brunswick to have the firmware updated to a version 1.1.22 or higher. Removal of the 360 Control Box Slide-Out tray is obtained by loosening 8 Phillips head screws and gently sliding the tray towards you. Temp Fix: If a lock up occurs, cycling power to the machine should clear it up temporarily and present a Slide out PCB heartbeat that is expected. |